Colorado Fisherman Forum banner

Gloomis warranty Service Changes

4461 Views 15 Replies 11 Participants Last post by  FSHHNTR

From G.Loomis:

We know fishing rods get broken. We all fish hard and put our tackle through plenty of abuse. But don’t kick yourself if you do break one, relax – G.Loomis will help you out with a simpler warranty process, and an expanded ‘Xpeditor’ service program.

We inspect every rod sent back to the factory, and if it’s a problem or break due to material or workmanship, G.Loomis will always cover it with our limited lifetime warranty. And now, when submitting a warranty claim, anglers no longer are charged a claim review fee. If the rod is covered by the warranty, a replacement rod is sent at no charge. If it’s not, anglers can pay $95 ($120 CAN for service to Canada) to replace any broken GL2 or GL3 rod, or $120 ($145 CAN) to replace any NRX, GLX, Pro4X, IMX or blended graphite rods.

If you broke it – accidents, misuse, normal wear and tear, G.Loomis supports anglers who appreciate its high-performance rods with the ‘Xpeditor’ service. It’s the fastest, easiest and most convenient way to replace a broken rod. For GL2 and GL3 series rods, the Xpeditor service fee is reduced to $75 ($100 CAN). The fee for all other G.Loomis rods – casting, spinning or fly – is $100 ($125 CAN). If you currently have a G.Loomis ‘Wildcard’ from buying an NRX or GL2 rod, G.Loomis will provide a one-time Xpeditor service replacement for no charge.

The G.Loomis rod warranty replacement program and the Xpeditor service is available to anglers in the U.S. and Canada. Visit, or call 877/577-0600, for more information.
1 - 1 of 16 Posts
Haven't fly fished in sometime but when I did I had a few Sages. In total sent them back three times all my fault and was never charged. However nothing is free in this country and the crazy rod prices we pay up front have already covered the future Oh ****'s
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.