Colorado Fisherman Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
4,811 Posts
Discussion Starter · #1 · (Edited)
Went to a lake NOT south east today.


They liked 1/4 oz silver.

Not slo and steady, but herky and jerky on the retrieve.

I don’t have a clicker, so here are my approximates .

Kept a few.

Released a good amount.

Missed a bunch.







 

·
Registered
Joined
·
171 Posts
PDog just because I installed a MG this morning, be sure to move that mount the 4" away from bow CL. I am not certain that it is needed, but they seem to think so.


Another hint be sure to check your clearances from all the gadgets on the bow with the side plates on. I caused myself an issue, that required a little post install adjustment.
 

·
Registered
Joined
·
4,811 Posts
Discussion Starter · #9 ·
PDog just because I installed a MG this morning, be sure to move that mount the 4" away from bow CL. I am not certain that it is needed, but they seem to think so.


Another hint be sure to check your clearances from all the gadgets on the bow with the side plates on. I caused myself an issue, that required a little post install adjustment.
Thanks Greg,

I have 1/2 inch clearance between the bow and the shaft when it's deployed, which is the minimum MG recommends for my specific motor.

I have a removable plate also which gives you a 4 inch setback when launching so you don't bang the motor when coming off the trailer.

I double checked clearances to make sure I can get to the front controls and I actually have better clearance for the removable bow light that I did with original mount Stratos installed.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top