Colorado Fisherman Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
377 Posts
Hey Kajitan,

I have a clam 1060,It's similiar to yours but is the A frame design. I dont recommend drilling holes inside the hut. After a couple of tries you should be able to pace of the distance between holes so you can drill holes and slide the hut over the holes.

As for anchoring the hut I use ice climbing screws with some rope connected to the grommets in the corners. They seem to work quite well but are a little expensive. Last month at 11 mile we fished in consistant 50mph+ winds and the ice screws worked great. If you are going to disassemble your hut in the wind leave the screws in on the windward side and take the hut down. It really helps keep the cover from blowing around.

FC
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top