Colorado Fisherman Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
can anyone help me, I have a 67 merc, 50 HP, I serviced the lower unit and now it only stays in gear, I have turned the little do-hicky that lines up with the shift shaft, but I cannot get "N" or "Rev".  I start it up and the prop turns for foward.  I can disconnect the cable linkage and it shifts fine, but when connected, it would get stuck and will not shift.  Any help out there?     ??? ??? ???


THANKS.
 
1 - 1 of 1 Posts
Top